Hurst Boiler S200-1S-0400-200 Two Pass Dry Back Scotch Marine Boiler (Steam Version)

Technical Specification

Features:

Make: Hurst Boiler
Model code: S200-1S-0400-200
Series: Series 200
Type: Fire tube
Design pressure: 14 bar

Additional info:

Boiler is of the two-pass, scotch type, built and stamped in accordance with the requirements of the ASME Code, and listed by the National Board of Boilers and Pressure Vessel Inspectors. Large combustion chamber with low heat release for complete combustion. Smoke box is front-mounted with slip-on stack connector. Access to fireside is accomplished with hinged and davited rear door (40 HP & larger) and with split front doors. Flame observation ports are on front and rear. Openings for cleanout inspection of waterside are provided with 3" x 4" hand holes, and with 12" x 16" manholes (80 HP up). Insulated with 2" high-density mineralwool, lagged with 22 gauge grip jacketing, baked on epoxy enamel to resist chipping and fading. Firetubes are rolled and beaded on power boilers, expanded and flared on low pressure boilers (2" dia. through 30 HP, 2 1/2" dia. 40 HP and up). Supports include lifting lugs securely welded to the top of shell; structural steel support legs on skids support the boiler so that special foundations are not required.

Contact manufacturer Contact manufacturer

Datasheet Datasheet

Make	Hurst Boiler
Manufacturer	Hurst Boiler & Welding
Category	Ships' equipment and fittings>Boilers
Model code	S200-1S-0400-200
Series	Series 200
Type	Fire tube
Design pressure	14 bar
Steam capacity	13,800 tons/hr
Fuel used	HFO (heavy fuel oil)
Power source	fuel oil
Depth	235 inch
Height	115 inch
Width	103 inch
Weight	15,377 Kg
Additional info	Boiler is of the two-pass, scotch type, built and stamped in accordance with the requirements of the ASME Code, and listed by the National Board of Boilers and Pressure Vessel Inspectors. Large combustion chamber with low heat release for complete combustion. Smoke box is front-mounted with slip-on stack connector. Access to fireside is accomplished with hinged and davited rear door (40 HP & larger) and with split front doors. Flame observation ports are on front and rear. Openings for cleanout inspection of waterside are provided with 3" x 4" hand holes, and with 12" x 16" manholes (80 HP up). Insulated with 2" high-density mineralwool, lagged with 22 gauge grip jacketing, baked on epoxy enamel to resist chipping and fading. Firetubes are rolled and beaded on power boilers, expanded and flared on low pressure boilers (2" dia. through 30 HP, 2 1/2" dia. 40 HP and up). Supports include lifting lugs securely welded to the top of shell; structural steel support legs on skids support the boiler so that special foundations are not required.
Download PDF version Download PDF version