Hurst Boiler S250-1S-0350-0150 Two Pass Semi Wet-Back Packaged Scotch Marine Boiler (Steam Version)

Technical Specification

Features:

Make: Hurst Boiler
Model code: S250-1S-0350-0150
Series: Series 250
Type: Fire tube
Design pressure: 10 bar

Additional info:

Boiler is of the two-pass, scotch type, built and stamped in accordance with the requirements of the ASME Code, and listed by the National Board of Boilers and Pressure Vessel Inspectors. Engineered to fit easily in a 40 ft shipping container Large combustion chamber with low heat release for complete combustion. Smoke box is front-mounted with slip-on stack connector. Access to fireside is accomplished with davited rear door and with split front doors. Flame observation ports are on front and rear. Openings for cleanout inspection of waterside are provided with 3" x 4" hand holes, and with 12" x 16" manholes (80 HP up). Insulated with 2" high-density mineral wool, lagged with 22 gauge grip jacketing, baked on epoxy enamel to resist chipping and fading. Firetubes are rolled and beaded on power boilers, expanded and flared on low pressure boilers (2" dia. through 30 HP, 2 1/2" dia. 40 HP and up). Supports include lifting lugs securely welded to the top of shell; structural steel support legs on skids support the boiler so that special foundations are not required.

Contact manufacturer Contact manufacturer Datasheet Datasheet

Make	Hurst Boiler
Manufacturer	Hurst Boiler & Welding
Category	Ships' equipment and fittings>Boilers
Model code	S250-1S-0350-0150
Series	Series 250
Type	Fire tube
Design pressure	10 bar
Steam capacity	12075 tons/hr
Fuel used	HFO (heavy fuel oil)
Power source	fuel oil
Width	85 inch
Weight	8426 Kg
Additional info	Boiler is of the two-pass, scotch type, built and stamped in accordance with the requirements of the ASME Code, and listed by the National Board of Boilers and Pressure Vessel Inspectors. Engineered to fit easily in a 40 ft shipping container Large combustion chamber with low heat release for complete combustion. Smoke box is front-mounted with slip-on stack connector. Access to fireside is accomplished with davited rear door and with split front doors. Flame observation ports are on front and rear. Openings for cleanout inspection of waterside are provided with 3" x 4" hand holes, and with 12" x 16" manholes (80 HP up). Insulated with 2" high-density mineral wool, lagged with 22 gauge grip jacketing, baked on epoxy enamel to resist chipping and fading. Firetubes are rolled and beaded on power boilers, expanded and flared on low pressure boilers (2" dia. through 30 HP, 2 1/2" dia. 40 HP and up). Supports include lifting lugs securely welded to the top of shell; structural steel support legs on skids support the boiler so that special foundations are not required.
Download PDF version Download PDF version